Near as step-by-step for those with Acekard2 and DS Lite:
- Avoid the original file unless you want to/can compile the file.
(In most cases, it WILL Guru error.)
- Register here at Neoflash. I had to as well, it's awkward but well worth it!
- Once registered go back to page 6, Stannum's post (#87).
- Grab dsvnc_release.zip (1687.7 kB). Don't see it? REGISTER and refresh the page!
- Extract dsvnc.nds from the zip.
- Install on Acekard2's Micro SD card.
- Run DSVNC!
After this you need a decent VNC program on PC-side. I recommend TightVNC - runs all three of my PCs remotely!
(And now that plus remote DS control!)
- Run the TightVNC Viewer on Listening Mode. Get this right or it WON'T work.
- Hover your cursor on the taskbar icon to get the IP address of your PC (192.6. - e.t.c).
- You will also need the Port number from TightVNC to get in with the DS.
- Also the password if you set one.
- From the DS:
-Turn on and run dsvnc.nds
- Add a new connection (IP:PORT - example: 192.345.2.8:1701 - 1701 being the port), hit enter.
- Choose view only or mouse and less colours or normal (trust me, less is faster!), hit Ok.
- Select the new connection (will highlight in red font), hit Connect.
- If a password is needed, type it in, hit enter.
IF SUCCESSFUL:
Your top screen will be the computer, bottom the zoomed view! Mouse is touch screen!
(D-Pad and all four buttons will be moving the zoomed area. Start swaps screens, Select brings up/puts back keyboard.)
Congratulations! You had more help than I did when I installed this, you lucky sod.
